Arduino Radio Control

RC Hobby Controllers and Arduino - SparkFun Electronics


May 22, 2012 ... Remote Control Arduino. Robots, cars, robotcars, and all sorts of prank devices require some degree of remote control. Most of the time, it's ...

How to Make a RC Controller - Arduino Project Hub


Apr 11, 2021 ... This project will show you how to make a RC Controller which communicates using 2.4GHz radio signal.

This DIY radio controller resembles one you'd find on the market ...


Mar 13, 2019 ... This DIY radio controller resembles one you'd find on the market ... If you've ever considered constructing your own wireless RC transmitter, be sure ... and toggle switches, along with an Arduino Nano for interface and control.

14 rc Projects - Arduino Project Hub


Read PWM, Decode RC Receiver Input, and Apply... · CARMAGEDDON: The Agile Arduino Car · Arduino GPS Drone RC Boat · Joystick Controlled RC Car.

DIY Arduino RC Transmitter - HowToMechatronics


The radio communication of this controller is based on the NRF24L01 transceiver module which if used with an amplified antenna it can have a stable range of up ...

rc-switch - Arduino Reference


rc-switch. Device Control. Operate 433/315Mhz devices. Use your Arduino, ESP8266/ESP32 or Raspberry Pi to operate remote radio controlled devices.

Using radio control underwater - Arduino Forum


Hello, I am trying to control a RC submarine under 2 meters of clear water (or very slightly salted, much less than the sea). I would need to send about three ...

RobotRemoteControl | Arduino


RobotRemoteControl. Examples > Robot. Remote Control. This example is considered experimental, you will need to install the IR-Remote library by Ken Shirriff ...

Remote control of LED with MKR GSM 1400 | Arduino Documentation


Jul 15, 2021 ... Learn how to control LEDs connected to your board, by sending text messages from your phone.

RC Control and Arduino: a Complete Works : 10 Steps - Instructables


1) Install batteries into Transmitter. Do not turn on yet! 2) Install bind plug into receiver. 3) Connect battery/BEC to receiver. 4) On the R8B a red led blinks rapidly. 5 ...